Electronic Educational Trainers,Educational Trainers Manufacturers
Home Page Didactic Products Training Kits OEM Trainers Send Enquiry Contact Us About Us
Didactic Trainers & Learning Systems
Technical Education Equipment  Educational Trainers
Technical Education Equipment  Antenna,Satellite,Radar,RF
Technical Education Equipment  Microwave Test Benches
Technical Education Equipment  Analog Electronics Trainer
Technical Education Equipment  Bread Board Trainers
Technical Education Equipment  Communication Trainers
Technical Education Equipment  Consumer Electronics Trainers
Technical Education Equipment  Digital Electronics Trainer
Technical Education Equipment  Educational Motors & Machines
Technical Education Equipment  Fiber Optic Trainers
Technical Education Equipment  Instrumentation Trainers
Technical Education Equipment  Power Electronics Trainers
Technical Education Equipment  Embedded / Microprocessor Trainers
Technical Education Equipment  Robotic Kits / Trainers
Technical Education Equipment  Hand Tools
Technical Education Equipment  Soldering, DeSoldering Stations
Technical Education Equipment  IC Testers & Programmers
Technical Education Equipment  Test, Measuring Instruments
Technical Education Equipment  Oscilloscopes
Technical Education Equipment  Meters (A,V)
Technical Education Equipment  Decade Boxes (R - L - C)
Technical Education Equipment  Variac / Dimmerstats
 
 
 
Home » Products » Educational Trainers » Power Electronics Trainers » Three Phase Half Controlled Thyristorized Bridge Converter With Triggering Circuit

Power Electronics Trainers » Three Phase Half Controlled Thyristorized Bridge Converter With Triggering Circuit

Three Phase Half Controlled Thyristorized Bridge Converter With Triggering Circuit DX

Three Phase Half Controlled Thyristorized Bridge Converter With Triggering Circuit

Three Phase Half Controlled Thyristorized Bridge Converter With Triggering Circuit Features:

Power Electronic Training Board has been designed specifically for the study of Three Phase Fully Controlled Thyristorized Bridge Converter with Triggering Circuit.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object:
* To study the nature and generation of Control Signal for 3 phase Full-wave Controlled Rectifier.
* To study the operation of a 3 phase Full-wave Controlled Bridge Rectifier with R load.
* To study the operation of a 3 phase Full-wave Controlled Bridge Rectifier with R-L load.
* To study the effect of Free Wheeling Diode on the output waveform.

Features:
The board consists of the following built-in parts:
01. Three Phase line commuted fully-controlled thyristorized bridge converter.
02. Three pole power contractor with AC coil complete with Push-to-ON switch.
03. Four pole Miniature Circuit Breaker (MCB).
04. Three separate idendical cards consisting of Zero Crossing Detector, Integrator, Comparator and Pulse Generator one for each phase, for
controlling the triggering angles of the positive group of three thyristors. Another card in conjunction with above three cards for
controlling the triggering angles of the negative group of three thyristors.
05. Firing angle control potentiometer.
06. Three 415 : 6 VTransformers AC supply for Triggering.
07. Three 415 : 50 V at 1 Amp Transformer for rectification.
08. ± 12V at 500mA, IC Regulator Power Supply for Triggering Circuits.
09. 5V at 500mA, IC Regulator Power Supply for Triggering Circuits.
10. Six nos. Driver Circuits with Pulse Transformers.
11. High Frequency Gated Dual Gate Firing 6 nos.
12. R and L load with Load voltage divider.
13. Two 3½ digital panel meter (DPM) for measurement of voltage and current.
14. One freewheel diode.
15. Unearthed mains sockets for CRO.
16. Adequate no. of other Electronic Components.
17. Three Jewel light in red, Yellow and Blue Colour
* The unit is operative on 3-f 415V at 50Hz A.C. Mains.
* Adequate no. of patch cords stackable 4 mm spring loaded plug length ½ metre.
* Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections/ observation of waveforms.
* Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book
References.
* Weight : 15 Kg. (Approx.)
* Dimension : W 445 x H 260 x D 470
Other Apparatus Required:
* Dual Trace Cathode Ray Oscilloscope 20MHz (Unearthed)

 

	Power Electronics Trainers Other Power Electronics Trainers

 

Educational Trainers & Teaching Products - Educational Trainers & Didactic Products for Technical Training in Universities, Engineering Colleges, Vocational Schools & Polytechnics Institutes

 

 
Educational Trainers & Teaching Products - Technical Teaching Equipment. Electronic Educational Equipment. Didactic Equipment for Technical Training. Engineering Teaching Equipment. Equipment for Electronics Engineering Education. Educational Trainers, Antenna,Satellite,Radar,RF, Microwave Test Benches, Analog Electronics Trainer, Bread Board Trainers, Communication Trainers, Consumer Electronics Trainers, Digital Electronics Trainer, Educational Motors & Machines, Embedded / Microprocessor Trainers, Fiber Optic Trainers, Instrumentation Trainers, Power Electronics Trainers, Robotic Kits / Trainers, Hand Tools, IC Testers & Programmers, Soldering,DeSoldering Stations, Test, Measuring Instruments, Oscilloscopes, Digital Storage Oscilloscopes, Power Supplies, Spectrum Analyzers, Signal Generators, Power Supplies, Decade Box (R, L, C), Variac / Dimmerstats.
Kits & Trainers

Educational Trainers  About Us
Educational Trainers  Didactic Products
Educational Trainers  Contact Us

© 2011 | Home